To get started with your W-AIR Headset, make sure you first connect the Headset to the W-AIR Base (transmitters). The Headset will keep the LED indicator off or it will long blink red.
Register your W-AIR Headset
- Press the Call, Volume Up (+) and Volume Down (-) buttons simultaneously and hold for 5 seconds.
- The Headset will connect to the W-AIR Base. The LED indicator will short and fast blink blue.
- Once the Headset is successfully registered (LED indicator will long blink blue and then short and slow blink blue), place the Headset in the charger for possible Firmware updates. This could take up to 10 minutes, do not take the Headset out of the charger meanwhile.
When the battery is charged for the first time, it is necessary to leave the Headset in the charger for at least 10 hours before the battery is fully charged, and the Headset is ready for use.